Link 1 down while connecting Orange PI to Pixhawk - Companion

Hi everyone, I’m trying to connect my Orange PI 3 to Pixhawk with telemetry. I make the connection below: I also enable the uart from the config file according to user mauel of the Orange PI and my UART3 port is active: When I run “mavproxy.py” in the command line I’m getting the output below: Auto-detected serial ports are: /dev/ttyS0 /dev/ttyS1 /dev/ttyS2 /dev/ttyS3 /dev/ttyS4 /dev/ttyS5 Those ports are exist but only the ttyS0 and ttyS3 active. My connections are true, I even tried

I want to communicate to pixhawk from Raspberry pi 3 and read the

Post 2. MAAXX-Europe. The Groundhog Hardware – Mike Isted

A source for Pixhawk info

Connections & Wiring Between Pixhawk 2.1 'CUBE' & Its Peripherals

Build A DIY Pi Zero Drone - Drone Dojo

Companion: Pi 2/3/Zero - Companion Computer Working Group - diydrones

5. Wiring and connecting Pixhawk to Raspberry Pi – RC Bellergy's

I want to communicate to pixhawk from Raspberry pi 3 and read the

6. Install and setup mavlink-router (connecting drone to ground

PX4 Research Log [8] – Hardware In the Loop (HITL) Simulation