Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

I received the PETG Basic Lake Blue filament on 12 July and immediately installed it in my AMS then kicked off a print using all the default Bambu Studio settings. The print had tons of stringing. I then dried the filament at 65C, re-calibrated my P1P, and set the K factor for the filament only to have the print fail again. I even slowed down from 200mm/s outer wall to 60mm/s without success. I have had no issues printing the same part using esun brand PETG. Has anyone else had issues with the

Bambu Lab PETG Basic - Troubleshooting - Bambu Lab Community Forum

Troubleshooting bad PETG print - Bambu Lab X1 Series - Bambu Lab Community Forum

Print has voids and gouges - Troubleshooting - Bambu Lab Community Forum

SOLVED] Bad quality when printing PETG - Bambu Lab X1 Series - Bambu Lab Community Forum

Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum

Sudden X1C Print Quality Issues - Troubleshooting - Bambu Lab Community Forum

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics - esk8.news: DIY Electric Skateboard Forums

Troubleshooting bad PETG print - Bambu Lab X1 Series - Bambu Lab Community Forum