My Arduino project essentially consists of an ESP32-CAM sending a photo to my Telegram group every 15min, then goes to sleep. When it wakes up, it evaluates the "brightess level" by reading the voltage from an LDR, if the brightness level is too low (night time), it goes back to sleep; otherwise it connects to the internet, takes a photo and sends it to me. I am aware the ADC pins of the ESP32 are distributed between ADC1 and ADC2 and that ADC2 should not be used when Wifi driver is in use. I a
How to use ESP32 ADC Peripheral? Tutorial on ADC in ESP32
ESP32/ESP8266 ADC with MicroPython - Measure Analog Readings
ESP32-CAM AI-Thinker Pinout Guide: GPIOs Usage Explained
ESP32-CAM - Getting Started & Solving Common Problems
Orange ESP-32 Cam IoT Kit - Orange Learning Kits Tutorials
ESP32 Cam - Compatible EZB Robot Hardware - Support - Synthiam
ESP32 Analog Input with Arduino IDE
ESP32 ADC – Read Analog Input in Arduino IDE – DeepBlue
ESP32 CAM - Pinout
ESP32/ESP8266 ADC with MicroPython - Measure Analog Readings
Aokin ESP32-CAM Camera Module, ESP32 Development Board WiFi and Bluetooth with OV2640 2MP Camera for Arduino, Include ESP32-CAM-MB Micro USB to Serial Port CH340C, 2 Pcs : Electronics
ESP32 Analog Input with Arduino IDE